Welcome to Discuss Everything Forums...

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.


 

Tags for this Thread

+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    Michael's Avatar
    Senior Member

    Status
    Offline
    Join Date
    May 2009
    Posts
    3,167
    Thanks
    0
    Thanked
    0
    Downloads
    0
    Uploads
    0
    replace the swicth. Jumping two wires is a way of getting the window to roll up, but those 30 wires actually go to a circuit panel. My suggestion is take it to the dealer cause the reason the switch melted is a short. either the window regulator is frozen(they use a cable system, that is part of the regulator, one cable pulls up and one down)or the cable is broken, or the motor is frozen. just jumping the wires might cause a short, melt your wires and cause a fire. I have seen cars burn to the groung from electrical fires from people trying to attempt similar bypasses. Is a 1-200 dollar repair worth replacing your truck.explaining such a bypass would only be possible with the wiring diagram, and even if you knew the colors and the regulator or motor was shorted, it would melt wires. you might try this
    remove your door panel and try to add 12 volts to the motor itself
    once you remove the panel, and the paper moisture cover that is attached with glue(careful not to rip)find the motor wires
    it should have two or three wires(most have two)you need 12 volts + and - .supply it with voltage, but if the window does not go up reverse polarity. also make sure you unplug the motor from the rest of the cars wiring
    goodluck
    Michael

  2. #2
    PAT A's Avatar
    Senior Member

    Status
    Offline
    Join Date
    Jul 2009
    Posts
    229
    Thanks
    0
    Thanked
    0
    Downloads
    0
    Uploads
    0

    2006 Chevy Trailblazer Window Stuck Down?

    It's 40 degrees and raining!! My drivers side windows is stuck down. Fuse and breakers all fine...Found a MELTED switch!! Does anyone know how to jump the switch to get the window back up? There are about 30 wires going to the switch...supposedly the blue or brown wire was up and down - I jumped those with a hot but nothing happened...Any ideas?

 

 

Quick Reply Quick Reply

Click here to log in


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 0
    Last Post: 05-18-2010, 01:18 PM
  2. Replies: 2
    Last Post: 01-26-2010, 11:59 AM
  3. Replies: 1
    Last Post: 06-27-2009, 07:03 PM
  4. Replies: 0
    Last Post: 06-27-2009, 11:04 AM
  5. Chevy Trailblazer stuck in reverse?
    By CuriousTay in forum GM
    Replies: 0
    Last Post: 03-29-2009, 02:02 PM

Bookmarks

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
  •  
 

SEO by vBSEO ©2011, Crawlability, Inc.